![]() ![]() See the document Cannot migrate Windows NT mirrored or striped sets to larger drives. ![]() Note that duplexed disks are a type of mirrored set. * Mirrored sets in Windows NT: To clone mirrored sets in Windows NT, break the mirror, run Ghost with the -NTIID switch ( -ntiid ), and then recreate the mirror using the Windows NT Disk Administrator. * SCSI or IDE: Ghost's ability to work with RAID arrays is not dependent on whether the array uses SCSI drives or IDE drives. Because the operating system needs the drivers for the array, the drives will be inaccessible on the destination computer unless the hardware is the same. * Use similar hardware: Restore the image file only to a computer that uses the same hardware as the source computer. Notes on getting Ghost to work with hardware RAID systems For other ASPI driver information, see the document Information on ASPI drivers. DOS ASPI drivers can usually be obtained from the RAID hardware manufacturer. Load the DOS ASPI driver when you create the image file and again when you restore the image file. * Ghost does support cloning drives that have had RAID removed, such as after you break a mirrored set.Īlthough it is not a supported feature, Ghost can sometimes create and restore images to hardware level RAID systems if you load the appropriate DOS ASPI driver to support this. * Although Ghost might work in some limited circumstances with hardware level RAID, Symantec does not support using Ghost for cloning hardware level RAID drives. * Ghost does not work with software level RAID. That is, Symantec Ghost 8.0 and earlier, and Norton Ghost 2003 and earlier, do not support RAID controllers on computers that are being imaged. Ghost is not compatible with computers that use RAID. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |